Bronkhorst Multibus Manual de usuario Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
BRONKHORST®
Page 9 Operational instructions for digital multibus instruments 9.17.023
2.3 MEASURE AND CONTROL FUNCTIONAL BLOCK DIAGRAM
The main part of a digital instrument is the measuring stage. The base is a highly accurate Analog to Digital converter.
The measuring signal is than processed trough a couple of stages as shown below. In general the path is: ADC scaling,
filtering, linearization (look-up or polynomial), Differentiation (gas flow sensors only), display filtering. In case of a
control system this signal is used to control a valve. The control loop consists of an enhanced PID controller (See the
chapter “Control parameters”).
Digital mass-flow measure / controller functional block diagram
ADC
converter
Bridge potmeter
ADC scaling
3
Bridge current
Exponential
smoothing
filter
4
Lookup table
linearization
Polynomial
linearization
Differentiator
5
6
7
8
Differentiator
filter
(MBC-II only)
1
Setpoint
0
Display filter
fmeasure
Measure
PID
controller
2
VALVE
SENSOR
FLOW
MEASURE
CONTROL
Monitor
Valve Out
MBC3
MBC-II
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Comentarios a estos manuales

Sin comentarios